Third Drupa Spotlight report published

In a survey (conducted before the coronavirus outbreak) over 500 printers and almost 200 suppliers described the challenges and successes of launching new products and services. For many in the industry, planning their recovery from the coronavirus recession may well necessitate such launches, so lessons must be drawn on how best to do so.
In most market sectors and most regions there are very challenging conditions. As for suppliers, they are only as healthy as their customers and they too must respond to the declining prospects for traditional products and services. For many the answer must be, at least in part, to launch new products and services.

Roughly 60% of printers launched major new products or services in the last four years into their existing markets. About half the launches were successful and very few went badly wrong. Diversifying the range of products/services and gaining new customers were chosen as the top benefits. As for the drawbacks, most reported that the launches sucked in far too much staff time and other resources and often ran well behind schedule.

About 30% of printers had launched into new market sectors. This is clearly a more difficult challenge and the results reflected that, with c.40% of the launches going well (compared with 54% for existing markets).

Turning to suppliers, approximately 80% launched new products/services over the last four years. The results were clearly better the larger the company with a success rate of 40% for the smallest suppliers up to 80% for the largest. The top benefits were diversification and gaining new customers. The biggest problems by far were launches running late and sucking in too many resources, while building the correct channels to market was a common challenge.

The report will draw four key lessons on how best to succeed when launching new products or services.

To purchase the full report go to www.drupa.com